ماژول تشخیص زاویه XD-79A مناسب جهت طراحی ربات
XD-79A factory direct 2-way switch dump angle sensor module angle sensor module
using the companys SW-520D tilt sensor sensitivity
the comparator output signal is clean, good waveform, driving ability, more than 15mA
adjust the sensitivity distribution position
the working voltage 3.3V-12V
(5. output format: digital switching outputs (0 and 1
a fixed bolt holes, easy installation
a small PCB board size: 3.2cm x 1.7cm
using a wide voltage LM393 comparator
:Module for use
The initial state of a two-way output from the tilt sensor depends on the conduction and off , when turned on , the green light , the output low , the tilt sensor is disconnected , the green light is off , output is high
Average tilt sensor are installed in an initial state in a normally open state , the inclination sensor is not in operation , extend the service life
Default SW-520D sensor for detecting objects dumped 90 degrees , for other angles , please consult the treasurer
the output can be directly connected to the microcontroller through the microcontroller to detect high and low , thereby detecting the angle of environmental change
the output of the relay module can directly drive the shop , which can be composed of a high- angle control switch